Both versions may set 5, but 5 doesn't have to mean the same thing. It takes the settings from the previous version's test.ĭXO sometimes changes the strength associated with a numeric value. Except you seem not to understand what's going on.Įach version does not reset to default. You are one sharp knife in the dyxum drawer, and I mean that, but if DXO10 likes to default to less effective standard NR numbers then.get DXO9 if you can! Ideally using separate copies for each version.

You must start with a clean fully reset file every time. When the second version overwrites the dop file it ends up with a mix of settings from previous and current versions. If a tool is added, removed, or redesigned, then the second version uses those settings it recognized, and not the other. The second version does not reset to its own defaults.

So each subsequent version used inherits the numeric values set by the previous. All version record all the settings, including the ones set by defaults. In addition the interaction between tools changes. Between versions, the tools available, the detail sliders within the tools and the strength of response in each setting caused by a particular numeric setting change. Regarding tests, if you use sidecars files for the settings and are opening the same file in all the versions, then you probably have corrupted the test.Įach version of DXO OP reads dop files written by others.

I haven't run careful tests to show you, but DXO standard NR has gotten better over the generations.

Noiseware vs dxo